Actron Switch Starter Switch User Manual

HEAVY DUTY STARTER SWITCH  
(WITH HOT CIRCUIT INDICATOR LIGHT)  
SAFETY GUIDELINES  
Always wear eye protection.  
Always operate vehicle in a ventilated area.  
Always keep people, tools, and test equipment away from moving and hot engine parts.  
Always make sure vehicle is in Park (automatic transmission) or Neutral (manual transmission) and parking brake is set.  
Always block drive wheels on vehicle.  
Always keep a fire extinguisher for gasoline/electrical/chemical fires near by.  
Always turn ignition key OFF when connecting or disconnecting electrical components, unless otherwise instructed.  
Always keep away from vehicle fans.  
Always follow vehicle manufacturer’s warnings, cautions, and service procedures.  
Never lay tools on vehicle battery.  
Never smoke or have open flames near vehicle.  
Never leave vehicle unattended while running tests.  
USING STARTER SWITCH  
The Heavy Duty Starter Switch With Hot Circuit Indicator Light is used to remotely operate starter on vehicles equipped  
with a starter solenoid. The Starter Switch has an added feature of a red light that glows when the starter switch is  
connected to a hot circuit and goes out when the button is pressed. This is a helpful indicator that tells when the Starter  
Switch is ready to use.  
1. Place vehicle in Park (automatic transmission) or Neutral (manual transmission), set parking brake and block drive  
wheels.  
To avoid damage to ignition system circuits or other circuits related to or connected to ignition  
wiring, follow all vehicle service manual instructions for disabling ignition system.  
!
CAUTION  
2. Follow vehicle service manual to disable ignition system.  
Use EXTREME CAUTION when connecting starter switch. Battery voltage is present at  
solenoid or relay and damage or injury can occur from shorting the leads.  
!
!
CAUTION  
CAUTION  
Follow all vehicle service manual instructions on how and where to connect Remote Starter  
Switch. ONLY connect Starter Switch to starter relay or solenoid. If switch is connected  
improperly, wires may become warm. If wires become warm, do not continue to push start  
button, as damage to Starter Switch may occur.  
3. Connect Starter Switch as stated in vehicle service manual.  
4. Turn vehicle ignition switch to the ON position.  
MAKE SURE HANDS AND STARTER SWITCH WIRES ARE AWAY FROM ALL BELTS AND  
FANS.  
WARNING  
!
5. Press START button on Starter Switch to crank engine.  
After disconnecting Starter Switch, reconnect all leads and connectors that were disconnected to disable  
the ignition system.  
IMPORTANT  
 

2nd Ave Radio F 12 User Manual
3Com Network Router Lynx L 510 User Manual
AEG Washer L 70470 FL User Manual
AL Tech MP3 Player Portable MPEG Player User Manual
AMD Computer Hardware GA M55S S3 User Manual
Asoka Network Router PL9920 BBR User Manual
Atlona Car Amplifier AT HD V14 User Manual
AVerMedia Technologies Satellite TV System 1500 MCE User Manual
Avocent Network Card SST 8P User Manual
Axor Sprinkler S 350 AIR User Manual